Configuring Router Startup Configuration: Best Practices

After configuring a router to ignore the startup configuration when the device boots, what command would you use to tell the device to load the startup configuration upon boot?

a) "boot-config start."

b) "reload-config start."

c) "load-config start."

d) "config-start load."

Answer:

The correct command to tell the device to load the startup configuration upon boot is option b) "reload-config start."

Explanation:

When you want the router to load the startup configuration upon boot after configuring it to ignore the startup configuration, you should use the "reload-config start" command. This command instructs the router to reload and apply the startup configuration during the boot process. It essentially reverses the previous configuration that ignored the startup configuration.

To break it down further, option a) "boot-config start" is not a valid command in Cisco router configurations. Option c) "load-config start" and option d) "config-start load" are also not standard commands in Cisco IOS. Therefore, option b) "reload-config start" is the correct and commonly used command for this purpose.

In networking and router configurations, accuracy is crucial, and using the correct command is essential to ensure the desired behavior of the device. Remember that the specific command syntax may vary depending on the router model and software version, so always refer to the documentation or the relevant command reference for your specific device to confirm the correct command.